P3427
Cylinder 4 Deactivation/Intake Valve Control Circuit Low
P3427 is set when the cylinder 4 deactivation solenoid circuit has a path to ground. GM uses it on several 2019 V8s: the DFM engine L84, the AFM engine L86 and the LT4 of the Corvette. Once the low-side output is switched off, less than half an ohm toward ground fails the check; 20 of 25 samples, relay voltage at least 11 V, 425 rpm (L84) or 400 rpm (L86, LT4), Type B. In all three tables the criteria column names cylinder 1, an apparent copy slip. For the MDS-equipped Hemi from Chrysler, one STAR case documents an exhaust manifold shield that rubs the solenoid harness open; a bared wire touching metal there can end up as this kind of short. P3428 covers the opposite short, to battery voltage.
Possible causes
- Control wire to the cylinder 4 solenoid rubbed through to ground, e.g. by a heat shield high
- Cylinder 4 solenoid shorted internally medium
- Moisture or oil in the solenoid connector low
- Damaged driver in the engine control module low
Symptoms
- Check engine lamp after two drives
- V4 or reduced mode never engages
- Further circuit codes on other deactivating cylinders if the harness is damaged
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3427
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.