P3420
Cylinder 3 Deactivation/Intake Valve Control Circuit High
P3420 reports that the cylinder 3 deactivation control line carries supply voltage where the module expects to pull it low. On GM's L84 the test runs only while the low-side output is switched on: a connection to battery voltage below 0.5 ohm, confirmed in 20 out of 25 samples, sets a Type B code. According to NHTSA's 2025 investigation into GM's DFM V8s, every cylinder has exactly one lifter oil solenoid, run by a peak-and-hold driver, so a single short disables the whole cylinder's switching. The Gen IV controller also has a separate high-side stage for this solenoid with its own codes, which helps tell which half of the circuit failed. P3419 covers the short to ground. The engine just keeps all eight cylinders working.
Possible causes
- Control wire of cylinder 3 touching a powered conductor high
- Shorted turns in the cylinder 3 solenoid winding medium
- Output transistor in the engine control module damaged low
Symptoms
- Check engine lamp on
- Fuel economy mode unavailable
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3420
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.