OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3419

Cylinder 3 Deactivation/Intake Valve Control Circuit Low

P3419 says the line feeding the cylinder 3 deactivation solenoid is dragged toward ground. The L84 V8 in GM's 2019 OBD documents shows the test: while the low-side output rests, a resistance to chassis ground under half an ohm is wrong, and once 20 out of 25 readings, one every 250 ms, agree, with the powertrain relay above 11 V and the engine at 425 rpm or faster, a Type B fault is logged. The lamp therefore follows on the second trip, and some controllers add P3417 at the same moment. The older 2007 Displacement on Demand table still merged short and open for cylinder 3 into one solenoid test. P3420 is the opposite fault, P3427 the cylinder 4 equivalent. Driving stays normal apart from the lost fuel saving.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 19

Possible causes

  • Insulation of the cylinder 3 control wire worn through to ground high
  • Internal short of the cylinder 3 solenoid to its housing medium
  • Oil or water bridging pins in the connector low
  • Defective driver in the engine control module low

Symptoms

  • Check engine lamp after two drives
  • Engine no longer drops cylinders under light load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3419

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication