P3417
Cylinder 3 Deactivation/Intake Valve Control Circuit/Open
P3417 flags a broken path in the drive circuit of the cylinder 3 deactivation solenoid. GM documents it twice: its 2007 Displacement on Demand table covers solenoid circuits on cylinder 1, 3 and 5 and needs 30 bad readings in 100 with the engine turning faster than 800 rpm; for the 2019 DFM engine L84, the ECM expects over 200 kohm whenever its low-side output rests, 20 of 25 checks, Type B. That controller also watches a high-side driver for the same solenoid under separate codes, and GM warns that P3419 may appear alongside. The LTA and LT2 V8s also put cylinder 3 to rest, together with 2, 5 and 8 (bulletin 20-NA-038). As long as the circuit is open, every cylinder keeps firing.
Possible causes
- Broken or chafed wire between control module and cylinder 3 solenoid high
- Open winding in the cylinder 3 deactivation solenoid medium
- Loose, oily or corroded solenoid connector medium
- Failed output stage in the engine control module low
Symptoms
- Check engine lamp on
- Reduced-cylinder mode no longer engages
- Slightly higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3417
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.