P3416
Cylinder 2 Exhaust Valve Control Circuit High
P3416 means the control line of a separate cylinder 2 exhaust valve actuator sits too high, typically because it touches a supply voltage or the coil has shorted turns. No manufacturer documents this code publicly. The closest published test is GM's for the intake-side P3412 on the L84: once the output stage is active, any resistance to supply below 0.5 ohm is a failure, and 20 hits out of 25 lead to a Type B entry. NHTSA's review of GM's DFM V8 describes one valve lifter oil solenoid per cylinder that serves intake and exhaust alike, which is why such engines need no exhaust-only code. CARB requires shorts in outputs to be detected. Related: P3413 open, P3415 short to ground, P3408 for cylinder 1.
Possible causes
- Actuator control wire shorted to a supply line medium
- Shorted turns in the cylinder 2 exhaust actuator coil medium
- Engine control module output stage fault low
Symptoms
- Check engine lamp on
- Engine stays in full-cylinder mode
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3416
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.