P3412
Cylinder 2 Deactivation/Intake Valve Control Circuit High
On GM's L84 V8 each cylinder, including cylinder 2, has a valve lifter oil solenoid bolted into the block valley. NHTSA's description of the system notes these solenoids are driven with peak-and-hold current for fast response. P3412 is set when the control line for cylinder 2 is shorted to supply voltage: GM checks it with the driver on and treats under 0.5 ohm to power as failed, 20 of 25 samples at 250 ms, Type B. In that state the computer cannot pull the solenoid properly and drops cylinder 2 from deactivation. Related codes are P3409 for an open circuit, P3411 for a short to ground and P3410 when the circuit is fine but the cylinder does not respond.
Possible causes
- Control wire shorted to a voltage feed in the harness high
- Low-resistance coil in the cylinder 2 solenoid medium
- Engine control module output stage fault low
Symptoms
- Check engine lamp on
- Cylinder deactivation no longer active
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3412
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.