P340B
Deactivation/Intake Valve Control Circuit Bank 2
P340B mirrors P340A for bank 2, the bank that does not contain cylinder 1, so it only applies to V or boxer engines. It marks an electrical fault in a control circuit that switches the intake valves of that whole bank at once. No manufacturer documents this code publicly. The widespread V8 systems put the deactivating cylinders of bank 2, cylinders 4 and 6 on GM and Chrysler engines, on their own solenoids and report them as P3425 or P3441. Honda's VCM V6 watches bank 2 via a rocker arm oil pressure switch and stores P3497. CARB asks for circuit checks of such outputs. The bank 1 counterpart is P340A, the bank 2 exhaust circuit P340D, the function code P341B. Usually the only effects are the lamp and lost economy.
Possible causes
- Chafed, open or shorted wire to the bank 2 actuator medium
- Oil or moisture in the bank 2 actuator connector medium
- Defective bank 2 intake deactivation actuator coil medium
- Engine control module output stage fault low
Symptoms
- Check engine lamp on
- Engine runs on all cylinders permanently
- Slightly higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P340B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.