OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P340A

Deactivation/Intake Valve Control Circuit Bank 1

P340A is meant for engines that switch the intake valves of a whole bank through a shared control circuit, rather than one solenoid per cylinder. It reports an electrical fault in that bank 1 circuit, without saying whether it is open or shorted. No manufacturer documents this code publicly, which leaves it without known limits; CARB merely demands that outputs of this kind be monitored for breaks and shorts. The common systems are built per cylinder: GM's DFM V8 has one solenoid per cylinder in the valley, so faults go to codes such as P3401. Honda's VCM V6 reports bank-level trouble as P3400. Bank 2 is P340B, the exhaust side P340C, the bank 1 function check P341A. Expect a warning lamp and no reduced-cylinder mode.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 0A

Possible causes

  • Damaged, open or shorted wire in the bank 1 control circuit medium
  • Corroded or loose connector at the bank 1 actuator medium
  • Bank 1 intake deactivation actuator with open or shorted coil medium
  • Output stage fault in the engine control module low

Symptoms

  • Check engine lamp on
  • Cylinder deactivation disabled on bank 1
  • Higher fuel consumption at light load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P340A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication