P3409
Cylinder 2 Deactivation/Intake Valve Control Circuit/Open
P3409 is the open-circuit code for the deactivation control of cylinder 2. GM uses it on two very different engines. On the 3.6 L V6 (LGX, LGZ) cylinder 2 is one of the two active fuel management cylinders, and an engineering bulletin links P3409 to oil leaking from the rocker arm oil control valve in the camshaft cover. On the L84 V8 with Dynamic Fuel Management every cylinder has a solenoid; GM flags an open circuit when it sees more than 200 kohm with the driver off, 20 of 25 samples at 250 ms, Type B. Shorts are P3411 and P3412, a mechanical failure P3410. The driver sees a warning lamp and loses the fuel-saving mode.
Possible causes
- Oil leaking at the control valve and soaking its connector (GM 3.6 L V6) high
- Broken wire or loose pin in the cylinder 2 solenoid circuit medium
- Open coil in the cylinder 2 deactivation solenoid medium
- Engine control module output driver fault low
Symptoms
- Check engine lamp on
- Oil residue around the valve cover control valve (V6)
- No reduced-cylinder operation, higher fuel use
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3409
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.