OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3404

Cylinder 1 Deactivation/Intake Valve Control Circuit High

P3404 is the short-to-power counterpart within the cylinder 1 group. GM tests it while the low-side driver is switched on: if the output still shows less than 0.5 ohm to supply voltage, the current has no proper path through the solenoid, and 20 of 25 samples at 250 ms set a Type B fault. The test only runs with at least 11 V at the powertrain relay and about 425 rpm (L84; 400 rpm on the L86). Ford names P3404 for the single deactivating cylinder of its VDE engines. Typical culprits are a control wire touching a supply line or a solenoid with shorted windings. Compare P3403 (short to ground) and P3401 (open).

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 04

Possible causes

  • Control wire shorted to a supply voltage in the harness high
  • Shorted winding in the cylinder 1 deactivation solenoid medium
  • Damaged output stage in the engine control module low

Symptoms

  • Check engine lamp on
  • Cylinder deactivation disabled
  • Possible further circuit codes on other solenoids if a shared supply is affected

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3404

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication