OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3403

Cylinder 1 Deactivation/Intake Valve Control Circuit Low

The engine computer drives the deactivation valve for cylinder 1 through an output stage that checks its own wiring. P3403 means that check found the control line pulled to ground. GM documents it for the L84 and L86 V8s (2019): with the driver off, an impedance below 0.5 ohm to ground counts as a fault, and 20 failures in 25 samples taken every 250 ms set a Type B code, so the lamp comes on after the second trip. Ford's VDE monitor flags the same short via its smart driver within 5 seconds. An open line is P3401, a short to battery voltage P3404, a mechanical failure P3402. The engine then stays in all-cylinder mode, mainly costing fuel.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 03

Possible causes

  • Control wire chafed against the engine and shorted to ground high
  • Internal short in the cylinder 1 deactivation solenoid medium
  • Oil or water in the solenoid connector low
  • Faulty output driver in the engine control module low

Symptoms

  • Check engine lamp on after two trips
  • Engine no longer switches to reduced-cylinder mode
  • Somewhat higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3403

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication