OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3402

Cylinder 1 Deactivation/Intake Valve Control Performance

This code reports that cylinder 1 does not respond as expected when the engine computer switches it off or back on, although the control circuit itself tests fine. Ford lists P3402 in its Variable Displacement Engine monitor for 2020-2023 gasoline engines: it runs continuously during deactivation, entry and exit, between 400 and 4500 rpm and once oil pressure has had about two seconds to build. GM handles the mechanical check for cylinder 1 under its own code P3498 instead. Wiring faults on the same channel set P3401, P3403 or P3404. A driver typically notices a warning lamp, a shake when the engine changes modes, or a misfire on cylinder 1.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 02

Possible causes

  • Low oil level, wrong viscosity or aged oil slows the hydraulic switching high
  • Switchable lifter or rocker of cylinder 1 sticking or not latching medium
  • Deactivation solenoid valve sticking or its oil screen blocked medium
  • Leaking solenoid seal lets control pressure bleed off low

Symptoms

  • Check engine lamp on
  • Shudder or jerk when the engine enters or leaves reduced-cylinder mode
  • Misfire on cylinder 1 (P0301)
  • Cylinder deactivation no longer used, higher fuel use

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P3402

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication