OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3401

Cylinder 1 Deactivation/Intake Valve Control Circuit/Open

P3401 points to a broken control path to the solenoid that switches off cylinder 1, a cylinder that GM and Chrysler V8s and Ford's 1.5 l three-cylinder EcoBoost all deactivate. On the 2019 L84 and L86 V8s, GM looks at the low-side output while it is off: over 200 kilohm to ground counts as open, and 20 failures among 25 readings at 250 ms intervals make it a Type B fault. GM adds that some controllers store P3403 alongside. Ford's VDE monitor relies on the fault status of its smart driver and decides within 5 seconds. For the 5.7 l Hemi, a Chrysler STAR case describes a deformed manifold heat shield that rubs the MDS solenoid harness open. P3403 and P3404 cover shorts, P3402 the mechanical function. Deactivation is then locked out.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 01

Possible causes

  • Control wire broken or worn through, e.g. by a hot exhaust heat shield high
  • Loose, corroded or oil-soaked solenoid connector medium
  • Open coil in the cylinder 1 deactivation solenoid medium
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine lamp on, on GM after the second trip
  • Engine stays in all-cylinder mode
  • Slightly higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3401

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication