P2EC2
Turbocharger Compressor Outlet Temperature Sensor Circuit Range/Performance
P2EC2 flags a compressor outlet temperature that is electrically valid but does not fit the operating point. A reference is easy to build: Cummins (US6401457) derives the outlet temperature from inlet temperature and pressure, turbo speed, air mass and pressure ratio, and after a long soak the sensor should also agree with intake and ambient readings. Under 13 CCR 1968.2 CARB wants such two-sided checks (section (e)(15.2.1)) and, in (f)(7), a watch on charge air cooler performance, which relies on the temperature entering the cooler; Ford's diesel test P026A scales its limits with compressor outlet temperature. No manufacturer documents P2EC2. Typical causes are a slow, drifted or oil-coated sensor, or one that has worked loose in its port.
Possible causes
- Sensor drifted or reacting too slowly high
- Tip coated with oil from crankcase or turbo seals medium
- Sensor loose or not reaching into the air stream medium
- Contact resistance at the connector low
Symptoms
- Check engine lamp after the fault is confirmed
- Reading disagrees with intake and ambient temperature after a cold soak
- Charge air cooler diagnosis may be suspended
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2EC2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.