P2EB3
Throttle Valve Intake Air Pressure Sensor Circuit Range/Performance
P2EB3 covers a throttle inlet pressure that is electrically fine but wrong. With the engine stopped, the pressure ahead of the throttle must equal manifold and barometric pressure; Ford checks this at key-up after at least 10 s off, allowing about 2.7 inHg between boost and manifold sensor. While running, GM compares its TIAP reading with an airflow model and fails it if the gap exceeds 30 kPa, reported as P0236. Nira Automotive's patent US5083434 shows why the value matters: the pressure drop across the throttle can replace the throttle angle when setting the boost target. No manufacturer documents P2EB3 publicly. Typical causes are a sensor drifting with age, a blocked or iced port, or a charge air leak that drags the model apart.
Possible causes
- Sensor offset or drift with age high
- Pressure port blocked by oil residue or ice medium
- Leak in the charge air path upsetting the model comparison medium
- Contact resistance in the connector low
Symptoms
- Check engine lamp on
- Pressure reading differs from manifold and barometric pressure with engine off
- Uneven boost or reduced power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2EB3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.