P2EB2
Throttle Valve Intake Air Pressure Sensor Circuit High
P2EB2 is stored when the throttle inlet pressure signal exceeds its upper limit. Since voltage climbs with pressure, the module would read a boost no charger can deliver. Electrically this points to a signal wire touching the 5 V reference or battery voltage, or to an open sensor ground that lets the output float up. No manufacturer documents P2EB2 publicly. GM files the high fault of its TIAP sensor under P0238 and sets it above 85.8 % of 5 V, about 371 kPa, again 320 of 400 samples and Type A; Ford's throttle inlet sensor fails above 4.88 V for 5 s. GM's patent US8090522 shows that the throttle controller works directly with this pressure, sampled every 12.5 ms, so a wrong value disturbs throttle control. P2EB1 is the low limit.
Possible causes
- Open sensor ground or corroded ground pin high
- Signal wire shorted to 5 V reference or battery voltage medium
- Pressure sensor failed high medium
Symptoms
- Check engine lamp, often after the first trip
- Boost limited, sluggish response
- Pressure reading far above ambient with the engine off
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2EB2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.