OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2EB1

Throttle Valve Intake Air Pressure Sensor Circuit Low

P2EB1 says the pressure signal at the throttle inlet is below the lowest valid voltage. These sensors are linear: Ford's transfer curve gives about 0.4 V at 20 kPa and 4.5 V at 300 kPa, so a low voltage reads as an absurdly low pressure. A missing 5 V reference, a signal shorted to ground or a failed sensor are the usual causes. No manufacturer documents P2EB1; for the same sensor under the boost code P0237 GM's 2025 gasoline table 25OBDG03B sets a fault below 14.4 % of 5 V (about 50 kPa) in 320 of 400 samples taken every 12.5 ms, Type A, and Ford below 0.19 V for 5 s. Since boost control relies on this pressure, the engine may limit boost. P2EB2 is the opposite limit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / B1

Possible causes

  • 5 V reference open or shorted, often shared with other sensors high
  • Signal wire shorted to ground medium
  • Pressure sensor failed medium

Symptoms

  • Check engine lamp, often after the first trip
  • Noticeable loss of power under load
  • Pressure reading far below ambient in live data

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2EB1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication