OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2EB0

Throttle Valve Intake Air Pressure Sensor Circuit

P2EB0 concerns the sensor that measures air pressure at the inlet of the throttle valve, i.e. between charger or air filter and throttle. On turbo engines this is the reading Ford calls TIP and GM TIAP; both makers, however, report faults of that sensor under the boost sensor codes P0236–P0238, and no manufacturer documents P2EB0 publicly. Ford's gasoline summary shows how widely the value is used: its PCV monitor P2282 needs a healthy TIP sensor before it runs. Bosch's comparable sensor sends pressure and temperature either on two analogue lines or digitally over a single SENT line, where garbled or missing messages would fit a general circuit code like this one. Low and high faults are P2EB1 and P2EB2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / B0

Possible causes

  • Loose, corroded or oil-wetted connector at the sensor high
  • Intermittent break in signal, reference or ground wire medium
  • Failed sensor electronics, e.g. SENT output medium

Symptoms

  • Check engine lamp on
  • Reduced boost or hesitant acceleration if a substitute value is used
  • Other air system checks such as the PCV monitor may not run

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2EB0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication