P2EAB
Active Radiator Air Flow Control Module A Over Temperature
P2EAB means module A of the active radiator air flow system reports that its own electronics have overheated. Such smart actuators carry their motor driver on board and protect it: J2012 records the matching case for the grille shutter as P05C0, where the actuator switches its output stage off when the chip runs too hot. Typical triggers are a motor straining against ice, dirt or a jammed linkage, a mounting place close to the radiator in hot weather, or an internal fault. Hyundai and Kia's patent US11225900 shows where such modules sit, directly between bumper opening and radiator. No manufacturer documents P2EAB publicly. While the module is off, the flaps remain where they stopped; if they stay closed under load the engine can run hotter, otherwise fuel use and warm-up suffer.
Possible causes
- Flaps blocked by ice, dirt or a damaged linkage, motor overloaded high
- High heat at the mounting place near the radiator medium
- Internal fault in the module or its temperature sensing medium
Symptoms
- Check engine lamp on, where the maker assigns a MIL
- Flaps stop moving for a while
- Higher coolant temperature under load if the flaps are stuck closed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2EAB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.