P2EA8
DC/AC Converter A Input Voltage Too High
P2EA8 is the reverse of P2EA7: the DC input of converter A lies above its permitted window. In the 12 V design of Toyota Industries' patent US10050558 the inverter stops once the battery side exceeds about 16 V, for example after a jump start from a 24 V source or with a failed alternator regulator. Unlike the low-voltage case it does not simply resume, but waits for a reset such as switching the vehicle off and on or unplugging the loads. Where the converter hangs on the high-voltage bus, as in Ford's Pro Power layout (US11043801), an overvoltage points to the traction system rather than to the converter. No manufacturer documents P2EA8 publicly. The sockets switch off to protect the unit and the connected devices.
Possible causes
- Charging system overvoltage from a faulty alternator regulator or DC/DC converter high
- Jump start or charging with too high a voltage medium
- Faulty input voltage measurement inside the converter low
Symptoms
- AC sockets switch off and stay off until a restart
- Other overvoltage messages or flickering lights
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2EA8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.