P2EA5
Exhaust Gas Temperature Sensor Circuit Range/Performance Bank 1 Sensor 6
P2EA5 is the plausibility fault of the sixth bank 1 exhaust probe: the voltage is electrically valid, yet the temperature does not match what the exhaust is doing. California's rule 13 CCR 1968.2, section (e)(15.2.1), like §1971.1 for heavy-duty engines, asks for two-sided rationality checks and names exhaust temperature sensors that steer a catalyst temperature strategy. No manufacturer publishes P2EA5. GM's 2025 diesel check for probe 5 (P2483) shows the method: after more than 10,800 s engine off, the value frozen at key-on is the reference, and if the probe then rises less than a calibrated map expects, it is judged stuck or out of the gas stream. Typical causes are a probe pulled from its boss, soot-coated or drifting elements, or two probes swapped at their plugs.
Possible causes
- Probe loose or pulled from its boss after exhaust work high
- Drifting element or soot-coated tip reacting too slowly medium
- Neighbouring probes swapped at their connectors medium
- Contact resistance in the connector shifting the reading low
Symptoms
- Check engine lamp after two trips
- Probe 6 stays flat or lags while other probes heat up
- Regeneration interrupted or not started
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2EA5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.