P2EA3
Exhaust Gas Temperature Sensor Circuit Low Bank 1 Sensor 6
With P2EA3 the input of the sixth bank 1 exhaust probe drops below the lowest value a healthy circuit can deliver. Electrically this is nearly always a short: the signal wire touching ground or the exhaust, or an element whose insulation has broken down. What the module displays differs by type, as Hella explains for divider circuits: a shorted NTC probe looks red hot, a shorted platinum (PTC) probe looks frozen. No manufacturer documents P2EA3; GM's code P2481 for probe 5 serves as a guide, set below 1 Ω or, with a digital thermocouple, colder than about −73 °C in 19 of 25 samples as Type B, i.e. MIL after two trips. A wrong low value can mislead the module about exhaust heat, so regeneration or SCR dosing may be held back.
Possible causes
- Signal wire chafed through to ground or to the exhaust pipe high
- Probe with internal short after thermal or mechanical damage medium
- Water or road salt bridging the connector pins medium
Symptoms
- Check engine lamp after the second faulty trip
- Probe 6 reads far too hot or far too cold depending on type
- Regeneration or SCR dosing held back
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2EA3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.