OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2EA2

Exhaust Gas Temperature Sensor Circuit High Bank 1 Sensor 6

P2EA2 says the signal of the sixth bank 1 exhaust probe sits above its upper electrical limit. Which temperature that implies depends on the element. Most probes form a voltage divider with a pull-up resistor in the module; an open lead then drives the input to the reference, which an NTC part reads as extreme cold and a platinum (PTC) part as extreme heat. Heraeus notes that both platinum resistors and thermocouples are used beyond 900 °C. No maker documents P2EA2; the closest public analogue is GM's probe 5 code P2482 in 25OBDG04A: more than 100 MΩ, or above about 1290 °C on a digital thermocouple, in 19 of 25 samples, Type A with the lamp after one trip. An unplugged connector or broken lead is therefore the prime suspect.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / A2

Possible causes

  • Open signal or ground lead, or connector not latched high
  • Probe element burnt open after overheating or vibration medium
  • Signal wire shorted to the 5 V reference or battery voltage low

Symptoms

  • Check engine lamp, often after a single trip
  • Probe 6 shows an impossible extreme value in live data
  • Filter regeneration or SCR dosing restricted

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2EA2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication