OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2EA0

Charge Port Door B Unlock Control Circuit High

P2EA0 marks the opposite case at the flap B release output: the line sits at a high voltage while the driver stage should be pulling it down or keeping it off. Contact with a 12 V circuit does this, and on low-side switched outputs an interrupted actuator or wire gives the same reading. No manufacturer documents P2EA0 publicly. GM's Volt checks the A output for a short to battery or an open line only while no release is commanded, needing 64 of 80 samples at 50 ms, and reports it within P0CD1. Tesla's latch patent explains why a permanently powered release is unwanted: the electromagnet is fed only briefly through a normally open switch to cancel the holding magnet. Audi's e-tron campaign 93H6 shows the fallback when a flap stays shut, the manual release. Low-level faults are P2E9F, the movement check P2E9E.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / A0

Possible causes

  • Control wire of the flap B actuator shorted to 12 V high
  • Open actuator winding or broken wire on a low-side driven output medium
  • Output stage in the control unit stuck on low

Symptoms

  • Flap B never releases, only the manual release helps
  • Actuator may run warm if powered permanently

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2EA0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication