OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E9E

Charge Port Door B Unlock Control Circuit Performance

P2E9E is a function check: the control unit commands flap B to unlock and then expects the position sensor to confirm an open flap. GM's tables for the A flap of the Volt set P0CD2 when that report is missing after 5 seconds (2011) or 13 seconds (2013, only above minus 12 °C), skip the test while position or output codes are active, and use Type B. No manufacturer documents P2E9E publicly, but Audi bulletins show the mechanical side on two-flap cars: on the e-tron the flap lock actuator can break if the flap is forced (2080912/1), on the Q6 e-tron broken gears in the flap motor leave it rocking at one spot (2077931/1), and on the A6 e-tron software could release the second flap's lock before the first was fully shut (2079918/1). P2E9D covers the electrical circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 9E

Possible causes

  • Flap B lock actuator or motor gears broken, often after force on the flap high
  • Flap B frozen, dirty or binding in its housing medium
  • Software sequencing error between the two flaps medium
  • Position sensor not reporting the opened flap low

Symptoms

  • Flap B pops slightly or rocks but does not open fully
  • Flap B moves freely by hand because the actuator is broken
  • Charging flap warning, charging only on the other side

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E9E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication