P2E9B
Charge Port Door B Position Sensor Circuit High
P2E9B is the high-side position fault of charge flap B: the reading lies above anything a working sensor can deliver. A signal wire touching 12 V, or a missing sensor ground, letting the input drift upwards, are typical explanations. No manufacturer documents P2E9B publicly. GM's Volt tables show the A version P0CCF flagging readings over 94.5 percent of the reference once six of eight samples agree, spaced 50 ms in 2011 and 500 ms in the 2013 table, as a Type B code. In GM's magnet sensor patent the door signal mainly drives an open-door warning and the interlock between two doors, so a stuck reading tends to produce a permanent flap-open message. Low readings are P2E9A, implausible but valid ones P2E99. The driver typically cannot charge on either side until the fault is gone.
Possible causes
- Position signal wire shorted to a 12 V feed high
- Broken ground wire of the flap B position sensor medium
- Corroded or loose connector at the flap module medium
Symptoms
- Permanent message that a charging flap is open
- Charging not possible on either side
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E9B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.