OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E9A

Charge Port Door B Position Sensor Circuit Low

P2E9A reports that the flap B position signal has fallen under its lowest valid value. A signal wire chafed against ground, water in the connector or an internally shorted sensor are the usual reasons. Tesla's latch patent shows a common build in which a reed or Hall element inside the latch senses a magnet disc on the door, so the signal follows the gap between them. No manufacturer documents P2E9A publicly. For the A flap of the 2011 Volt, GM sets P0CCE as Type B when 6 out of 8 readings fall under 22.9 percent, and while a position code is active it holds back the control pilot test P0CF4 and the opening check P0CD2. P2E9B is the high counterpart, P2E98 the general circuit code. Expect a flap state that never changes and possibly blocked charging.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 9A

Possible causes

  • Position signal wire of flap B shorted to ground high
  • Water in the sensor connector at flap B medium
  • Position sensor failed short internally medium

Symptoms

  • Flap B status in the display does not change
  • Charging blocked or charging flap warning

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E9A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication