OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E99

Charge Port Door B Position Sensor Circuit Performance

P2E99 means the position signal of charge flap B is within its electrical limits yet contradicts what the flap is doing, for instance closed although the flap was just opened. On cars with two flaps such an error has side effects, because the flaps lock each other: Porsche found on the 2020 Taycan that a bad sensor signal led to a wrong end-position decision, which then blocked the flap on the other side, and replaced both flap harnesses (campaign WLK2); a GM patent describes the same interlock with a magnet sensor per door. Audi reports two e-tron GT cases where a closed flap was read as open: a faulty actuator with oxidation or particles (2064953/4) and, later, cockpit software (2079475/1). No manufacturer ties these to P2E99 publicly. Pure circuit faults belong to P2E98, P2E9A and P2E9B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 99

Possible causes

  • Position sensor or its harness giving a wrong end-position signal high
  • Oxidation or particles in the flap actuator that houses the detection medium
  • Software misreading the flap state at start-up medium

Symptoms

  • Message asking to close a charging flap although both are closed
  • Opposite flap A locked and not operable
  • Charging refused

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2E99

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication