OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E95

Charge Port Door B Open Request Switch Circuit Low

P2E95 says the request signal from charge flap B has dropped under the bottom of its permitted range. Usual reasons are a signal wire touching ground, water bridging the connector pins or an internally shorted sensor. Depending on the wiring, the control unit may take this as a button held down all the time. No manufacturer documents P2E95 publicly. For the A flap, GM's 2011 Volt table sets P0CC9 once 6 out of 8 readings stay under 22.9 percent, and treats it as Type B. Water at flap connectors is a known weak point on two-sided designs: Audi's campaign 93H6 for the e-tron sealed or replaced the connectors in the charge door units on both sides because moisture could leave the flap openable only with the manual release. High readings are P2E96, invalid middle values P2E93.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 95

Possible causes

  • Signal wire of the flap B sensor shorted to ground high
  • Water in the flap B connector bridging the contacts medium
  • Request sensor of flap B failed short internally medium

Symptoms

  • Flap B does not open on touch, or only with the manual release
  • Control unit may stay awake longer, raising standby drain
  • Charging flap warning displayed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E95

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication