P2E8E
Battery Charger B Charge Sequence Signal 2 Circuit High
P2E8E concerns the second CHAdeMO sequence line, which works differently from the first: the station closes switch d2 to tie the line to ground, completing the circuit that sequence signal 1 feeds, and only then may the vehicle close its high-voltage contactors. Before that the connector has been latched and the vehicle has given charge permission. If the vehicle measures this line and finds it high at the moment d2 should be closed, the go-ahead for the contactors never arrives and the session ends just before power transfer; a high level outside a session points to a short to a supply. An open wire on pin 10 or a station whose d2 fails can look the same. No manufacturer documents P2E8E publicly. The low counterpart is P2E8F; faults on signal 1 are P2E8C/P2E8D.
Possible causes
- Open wire or damaged pin 10 in the DC inlet high
- Fast charger switch d2 not closing medium
- Sequence signal 2 line shorted to a supply voltage medium
- Faulty input stage in the evaluating control unit low
Symptoms
- DC session stops after insulation test without current flowing
- Station shows a vehicle-side error
- AC charging still possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E8E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.