P2E8D
Battery Charger B Charge Sequence Signal 1 Circuit Low
P2E8D means the vehicle finds the first CHAdeMO sequence line low while the fast charger should be driving it. Signal 1 is the opening move of a session: once the plug is detected the station closes d1 and applies 12 V, and only after that does the CAN exchange of battery limits begin. If the vehicle side sees no voltage, the session stalls before any current flows. The line can also supply contactor coils in the car, which is why the standard allows up to 2 A on it; a short to ground therefore loads the station switch hard. No manufacturer documents P2E8D publicly. Reasons include a short to ground, a broken wire or pin 2 contact, a corroded inlet, and, on the station side, a switch d1 that never closes, so trying another charger helps narrow it down. The high counterpart is P2E8C.
Possible causes
- Sequence signal 1 line shorted to ground high
- Open wire or damaged pin 2 in the DC inlet medium
- Fast charger not closing its switch d1 medium
- Faulty input stage in the evaluating control unit low
Symptoms
- DC fast charging does not start
- Station reports a communication or vehicle error
- AC charging unaffected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E8D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.