P2E8C
Battery Charger B Charge Sequence Signal 1 Circuit High
Charge sequence signals 1 and 2 belong to DC fast charging to CHAdeMO, used for example on the Nissan Leaf, the Mitsubishi i-MiEV and the Outlander PHEV. Signal 1 runs over connector pin 2: the station closes its switch d1 and applies 12 V to the line, which tells the car it is ready and starts the CAN dialogue. P2E8C means the vehicle sees this line high when it should not, for instance with no station connected or after the station has opened d1 once a session is over, or the level exceeds the allowed range. Likely reasons are a short to a 12 V source in the harness or inlet, or a faulty input stage. No manufacturer documents P2E8C publicly. The car can then no longer trust the start and stop handshake and usually refuses DC charging. The low counterpart is P2E8D.
Possible causes
- Sequence signal 1 line shorted to a 12 V source high
- Moisture or debris in the DC inlet bridging pins medium
- Faulty input stage in the evaluating control unit medium
- Station switch d1 not opening at the end of a session low
Symptoms
- DC fast charging refused or ending with an error
- AC charging continues to work
- Charging fault message in the cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E8C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.