OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E8A

Proximity Detection Circuit B High

P2E8A is the opposite of P2E89: the proximity line of circuit B sits above the accepted band. Because the evaluating controller usually pulls the pin up to a reference such as 5 V, as described for Watt & Well's EVCC, an open wire or a missing earth path reads high just like a short to a supply. For circuit A GM's Volt sets P0D59 above 4.8 V under the same conditions as the low test, charge door closed or moving out of Park, again Type A with MIL. Mitsubishi's 2023 Outlander PHEV logs P0D59-00 on a high charger connection signal and points to the harness between charger and PHEV-ECU or the PHEV-ECU itself. No manufacturer documents P2E8A. The usual result is a plug on inlet B that is never recognised, so charging there does not start.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 8A

Possible causes

  • Broken proximity wire or unplugged connector at inlet B high
  • Missing protective-earth path in inlet or cable medium
  • Proximity line shorted to a supply voltage low
  • Evaluating control unit faulty low

Symptoms

  • Charging cable on inlet B is not detected
  • Charging does not start on that inlet
  • Warning lamp, depending on manufacturer the MIL

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E8A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication