P2E88
Proximity Detection Circuit B Range/Performance
P2E88 flags plug sensing on circuit B whose value is electrically valid but makes no sense, typically a voltage that falls between the defined steps for no plug, plug latched and release button pressed. Those steps come from fixed resistors: J1772 uses 150 Ω plus 330 Ω once the latch is opened, and IEC 62196 cables code their current rating with values from about 100 Ω to 1.5 kΩ, each read within a tolerance band. Supplier controllers such as Watt & Well's EVCC bias the pin with 5 V and treat less than 3.5 kΩ as a plug, more than 4 kΩ as none. No manufacturer documents P2E88; for circuit A FCA cured P0D57 on the 2017 Pacifica plug-in hybrid by reflashing its hybrid control processors. Worn contacts or an off-standard cable are common. Hard faults are P2E89 and P2E8A.
Possible causes
- Worn or dirty proximity contact raising the resistance high
- Charging cable or adapter with off-standard coding resistor medium
- Moisture in inlet B creating leakage paths medium
- Control software judging the signal wrongly low
Symptoms
- Charging aborts or the current is limited unexpectedly
- Plug status changes without anyone touching the connector
- Fault appears only with certain cables
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E88
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.