OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E87

Proximity Detection Circuit B

P2E87 is the general fault of a second plug-detection circuit, B, whose job is to tell the vehicle that a connector is seated in an inlet. Under SAE J1772 this proximity pin is tied to earth through resistors and a switch in the latch button, so the car can lock out driving and wind down current before the plug comes out; CHAdeMO inlets have their own proximity contact for the same interlock. A second circuit is needed where a car carries two inlets, as the Outlander PHEV does with its normal and quick-charge sockets: Mitsubishi reports the normal one as proximity A (P0D58/P0D59) and reads a separate quick-charger connecting voltage, without publishing a B code. No manufacturer documents P2E87. Lear patented a circuit that also wakes the charger through this line. Expect no charging on that inlet.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 87

Possible causes

  • Damaged or corroded proximity contact in inlet B high
  • Open or poorly seated connector between inlet B and the controller medium
  • Faulty charging cable or plug resistor medium
  • Evaluation circuit in the charger or control unit faulty low

Symptoms

  • No charging through the affected inlet
  • Plug not recognised or vehicle reports a cable while none is fitted
  • Vehicle may refuse to enter drive readiness

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E87

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication