OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E83

Fuel Rail Pressure Performance - Engine Off

P2E83 covers a fuel rail pressure check that runs once the engine is shut down: the residual pressure in the rail falls too fast, stays too high or behaves implausibly. No manufacturer documents the code publicly. For monitors active at standstill, CARB extends the driving cycle through the shutdown period until the next start. Patents show what such a check looks at: GM measures rail pressure a set time after shutdown, fires an injector to bleed it if it is still above a limit (about 5 MPa in the diesel example) and flags a fault if it stays high; Ford lists rail pressure decay with the engine off as a way to find leaking direct injectors. Ford's 2024 summary covers rail pressure only while running, cranking and in cold start (P0087, P0088, P00C6, P053F).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 83

Possible causes

  • Injector leaking into the cylinder, so rail pressure decays too quickly high
  • Leaking pump check valve or pressure relief valve medium
  • Rail pressure sensor with offset or drift, implausible at rest medium
  • Pressure rising after shutdown from heat soak with no way to relieve it low

Symptoms

  • Check engine light
  • Long cranking or rough start after the car has stood
  • Possible fuel smell or smoke right after starting

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E83

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication