OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E82

Cold Start Engine Coolant Pump Overspeed

P2E82 flags an electric main coolant pump that spins faster than requested while the cold-start warm-up strategy runs. GM's 2025 ECM tables (25OBDG03B) subtract reported from requested speed, filter the result and fail the test when it falls below −200 rpm in 8 of 10 seconds; Type B, MIL after two trips. Required: low-flow coolant mode, catalyst warm-up active, a request that changes by less than 50 rpm per sample for 3 s, and inlet coolant at −40 °C or warmer. Outside cold start GM uses P26CE with a speed-dependent limit of −200 to −800 rpm. A pump that turns too freely often moves air instead of coolant, so low coolant or trapped air are the first suspects. A GM patent compares pump speed and current with targets to find such faults.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 82

Possible causes

  • Low coolant level or air trapped after service, so the impeller runs dry high
  • Impeller loose or damaged, so the motor turns without load medium
  • Faulty pump electronics or speed feedback signal medium
  • Flow path blocked by a stuck valve, changing the pump load low

Symptoms

  • Check engine light after two trips
  • Gurgling noises or weak heater output
  • Rising engine temperature if coolant is missing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2E82

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication