OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E80

A/C Compressor Control Module Internal Temperature Sensor B Circuit Intermittent/Erratic

With P2E80 the controller sees the reading of sensor B, a second internal thermometer in the compressor electronics, flicker: values leap or vanish for an instant and then look normal again. Set criteria for P2E80 are not published by any manufacturer. For the 2019 Volt, GM lists the IGBT counterpart P0D79 merely as a code that must be inactive before its rationality check P0D76 starts. A Hyundai patent dealing with sensors on inverter power switches separates the patterns: dropouts spread irregularly over time point to bad contact, whereas a value stuck at one number suggests a short. Loosened board connectors, cold solder joints and interference are prime suspects. Rule out the low-voltage feed, ground and network line first; when the fault stays, the compressor assembly is normally replaced as one unit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 80

Possible causes

  • Loose contact or cold solder joint in the sensor B circuit high
  • Electrical interference from the inverter switching on the measuring line medium
  • Fluctuating 12 V supply or ground of the compressor controller low

Symptoms

  • A/C cuts out and recovers sporadically
  • Fault may be stored without any noticeable effect

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2E80

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication