OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E7F

A/C Compressor Control Module Internal Temperature Sensor B Circuit Low

P2E7F is the low-signal counterpart: sensor B inside the compressor control module reports a value below its valid band, which for a sensor with falling output means an impossibly hot reading. GM's comparable code on the compressor IGBT sensor is P0D78: the 2011 Volt fails above 274 °C, the 2018 and 2019 tables above 150 °C, with the compressor detecting the condition itself and passing it on over GMLAN, Type B. No manufacturer documents P2E7F. A short on the sensor path is the usual explanation. Genuine overheating of the power stage, for instance from too little refrigerant flow, should still be ruled out, because controllers like the one in a Mitsubishi Heavy Industries patent slow or stop the compressor when it runs too hot. The cold side is P2E7E.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 7F

Possible causes

  • Short circuit in the sensor B path on the control board high
  • Power stage genuinely overheating, e.g. low refrigerant charge low
  • Measuring circuit of the compressor controller defective medium

Symptoms

  • Compressor derates or shuts down for overheat protection
  • Air conditioning blows warm, battery cooling may be limited
  • MIL possible after two drive cycles depending on manufacturer

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2E7F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication