OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E7E

A/C Compressor Control Module Internal Temperature Sensor B Circuit High

P2E7E reports that internal temperature sensor B of the A/C compressor controller delivers a signal above its valid range. Most sensors of this kind produce a voltage that falls as temperature rises; TI's compressor inverter reference uses such an analog part, so a high signal stands for an impossibly cold reading. GM applies exactly this to the IGBT sensor of its compressor: P0D77 sets when the reported value falls under −40 °C, in the 2011 Volt after 30 failures within 60 samples taken every 50 ms, provided ambient exceeds −7 °C, in 2018 at a 100 ms rate and in 2019 after 4 of 5 s, always Type B. No manufacturer documents P2E7E. An open sensor path, a cracked solder joint or a lost reference on the board are usual causes. In J2012 this High code precedes the Low code P2E7F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 7E

Possible causes

  • Sensor B path open, e.g. cracked solder joint on the board high
  • Reference or ground of the measuring circuit lost inside the module medium
  • Analog input of the compressor controller defective low

Symptoms

  • Compressor runs restricted or not at all
  • Cabin and, where present, battery cooling weaker
  • MIL possible after two drive cycles depending on manufacturer

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2E7E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication