P2E74
Hybrid/EV Battery Pack Coolant Temperature Sensor D Circuit
P2E74 covers any circuit fault of coolant temperature sensor D, the fourth such sensor a maker can fit to the battery's liquid cooling. Battery controllers typically watch coolant at the pack inlet and outlet; GM's Volt and ELR tables use sensor A for the inlet and B for the outlet. Where a sensor D sits is not public. No manufacturer documents P2E74 publicly. Such sensors are sealed NTC thermistors; one supplier part for battery coolant reads 2828 ohms at 25 °C. GM's 2011 Volt runs its coolant sensor range checks only while no fault is active on the battery controller's 5 V reference circuit. CARB requires the inputs of battery heating and cooling to be monitored. Without the value, cooling may run on substitute data and power can be limited.
Possible causes
- Damaged wire, loose connector or corroded terminal at sensor D high
- Fault on the shared 5 V reference circuit of the battery controller medium
- Coolant temperature sensor D failed medium
Symptoms
- Hybrid system or check engine light
- Battery cooling or heating not working as intended
- Reduced electric power or charging rate
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E74
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.