P2E70
Hybrid/EV Battery Pack B Cell Thickness
P2E70 is the swelling code for a second high-voltage pack, B, in vehicles that carry two; which pack is A and which B is set by the maker. The controller judges that cells in pack B have grown too thick. No manufacturer documents P2E70 publicly. Research explains why thickness is watched at all. A University of Michigan patent reads the force on the module end plates and uses it to estimate capacity loss, and Southwest Research Institute derives aging from the strain at equal charge level, new versus aged. In real failures far more happens: in tests by the UK HSE a heated 5 Ah pouch cell released about 4 litres of gas on average, and the force of that swelling matters most where cells sit tightly packed. Pack A swelling is P2E6C.
Possible causes
- Cells in pack B aged and permanently thicker high
- Gas generation after overcharge, deep discharge or heat medium
- Poor cooling of pack B accelerating cell degradation low
Symptoms
- Hybrid or EV warning with power reduction
- Reduced range or charging blocked
- Vehicle may refuse READY
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2E70
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.