OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E6B

System Too Rich During Cylinder Deactivation Bank 2

P2E6B closes the set: bank 2 runs rich while cylinders are switched off. GM's 19OBDG07 tables (4.2-litre twin-turbo V8, LTA) fail the test when bank 2's deactivation-mode trim factor falls below 0.77 and has settled; Type B, two trips, same enable conditions as the other three codes. Typical systems keep the valves of the idle cylinders shut and stop fuelling them, so the shut cylinders act as air springs; if a valve or injector of a cylinder that should be off keeps working, measured air and real air per firing cylinder no longer match. Compared with P2E69 the fault sits on the other bank; a rich result on both banks suggests a common source such as purge vapour or fuel-diluted oil. GM calls the system Active Fuel Management.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 6B

Possible causes

  • Leaking injector on bank 2, including one on a cylinder that should be shut off high
  • Deactivation rocker or its oil-control solenoid not switching on one cylinder medium
  • Excess purge vapour or fuel-diluted engine oil medium
  • Bank 2 oxygen sensor reading biased lean low

Symptoms

  • Check engine light after two trips
  • Higher fuel consumption on the highway
  • Possible sooty tailpipe on bank 2 side

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E6B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication