OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E68

System Too Lean During Cylinder Deactivation Bank 1

P2E68 is a fuel trim fault that is judged only while cylinders are shut off: in that mode bank 1 needs more fuel correction than allowed. GM uses it on its 4.2-litre twin-turbo V8 (LTA, table 19OBDG07): the engine learns a separate multiplicative long-term trim for deactivation mode, and the code sets when that factor for bank 1 rises above 1.23 and has been steady for at least 10 s; Type B, MIL after two trips. Enables include coolant at 54.8 °C or more, intake air under 90 °C and no wide-open throttle. Full-engine lean faults use other codes, such as P2177. On that engine half the cylinders run in this mode, two per bank. A Ford patent explains why a faulty valve deactivator shows up as a bank-specific trim shift.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 68

Possible causes

  • Restricted injector on one of the cylinders that keep firing on bank 1 high
  • Unmetered air entering bank 1 (intake leak, seal, PCV) medium
  • Deactivating rocker or lifter on bank 1 not holding the valves shut, pumping air into the exhaust medium
  • Bank 1 oxygen sensor reading biased rich low

Symptoms

  • Check engine light after two trips
  • Slight shake or surge at light cruise when cylinders are shut off
  • Cylinder deactivation may be used less often

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E68

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication