OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E67

Engine Coolant Bypass Valve E Stuck Closed

P2E67 means valve E stays shut although the control asked it to open. No manufacturer documents valve E publicly. GM's closed-side test on block valve D (P26C2) shows the pattern: a gap of more than 5° between commanded and measured angle while the raw feedback stays below 50°, 4 of 5 seconds, Type B in the 2025 table 25OBDG03B; the test pauses during end-stop learning. Ford patents describe temperature-based checks instead: valves are closed one at a time and the coolant temperature reaction is compared with the expected one, and a transmission warm-up valve counts as stuck closed when the fluid fails to warm as expected after the open command. A closed valve can be harmless (heater path) or serious (block or radiator path, risk of hot spots).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 67

Possible causes

  • Valve jammed closed by deposits, debris or swollen seals high
  • Actuator motor or gearing unable to open the valve medium
  • Position feedback stuck at the closed value medium
  • Wrong coolant or trapped air after service upsetting the temperature-based check low

Symptoms

  • Check engine light
  • Little or no heat from the heater, or rising engine temperature, depending on the circuit
  • Possible reduced engine power to protect the engine

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E67

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication