P2E57
Exhaust Pressure Sensor C Circuit High
P2E57 reports a signal from exhaust pressure sensor C above the plausible ceiling. For sensor A Ford sets that ceiling at 4.80 V, on petrol engines checked while the EGR monitor runs and with 5 s to fail, on 2023 diesels with 2 s; in Ford's petrol transfer function 4.7 V already equals about 378 kPa. On a three-wire sensor a high reading usually comes from an open ground, a signal line in contact with the 5 V supply or a battery-fed circuit, or, depending on the input circuit, an open signal line pulled up inside the module. Soot or moisture in the sensing path rarely produce this electrical fault. No manufacturer publicly documents P2E57. After repair, clear the code and confirm that sensor C reads ambient pressure with the engine off. Low is P2E56, sensor A's high code P0473.
Possible causes
- Open ground circuit of sensor C high
- Signal wire shorted to the 5 V reference or battery voltage medium
- Open signal wire pulled high by the module input medium
- Internally failed sensor C low
Symptoms
- MIL on
- Boost or EGR control in substitute mode, possibly less power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2E57
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.