P2E50
Battery Charger Coupler Temperature Sensor D Circuit Range/Performance
P2E50 flags sensor D for delivering a believable voltage that the logic still rejects. A module can test this in several ways: compare D with a sensor on a contact that carries the same current, check whether it warms as expected under load, or look for steps no metal pin could make. Inlets that monitor both DC+ and DC-, as Amphenol's NACS inlet does with PT1000 elements, offer such a partner. Ford's special service message 55080 proves that its electric pickup, van and crossover read a sensor D, since it cites the overheating code P2E53, yet Ford publishes nothing on P2E50. No other maker documents it. CARB asks for rationality checks to be two-sided where feasible and stored apart from circuit codes. When D is distrusted, the car usually limits or refuses fast charging. P2E4F, P2E51 and P2E52 cover electrical faults.
Possible causes
- Sensor D has lost good thermal contact with its pin medium
- One contact heating far more than its partner due to wear or dirt medium
- Plausibility thresholds in the module software, update available medium
- Temperature element D drifted low
Symptoms
- DC fast charging limited or ended early
- AC charging may still work
- Charging warning message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E50
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.