P2E4D
Battery Charger Coupler Temperature Sensor C Circuit High
P2E4D is stored when the sensor C input rises above its upper limit. In a pull-up circuit that is the signature of an open loop, an unplugged connector or a short to a supply voltage. Read as temperature, it means very cold for an NTC, but very hot for a PT1000 or a PTC element. The Phoenix Contact patent US10256579 describes PTC elements wired in series on several contacts whose resistance climbs steeply once a set temperature is passed; seen from the module, a broken chain looks the same as a tripped one. Charge controllers such as Watt&Well's EVCC accept either PT1000 inputs, measured in a Wheatstone bridge, or NTC inputs on bias resistors, so what high means depends on how the input is configured. No manufacturer documents P2E4D publicly or gives limits. P2E4C is the low-signal sibling; P2E4E is real overheating.
Possible causes
- Sensor C loop open, for example a broken wire or unplugged connector high
- Signal wire shorted to a supply voltage medium
- Temperature element C or one link of a PTC chain open inside the inlet medium
- Measuring input of the evaluating module defective low
Symptoms
- Charging does not start or stops immediately
- Charging system warning
- Displayed inlet temperature stuck at an extreme value
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E4D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.