OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E4C

Battery Charger Coupler Temperature Sensor C Circuit Low

P2E4C says the voltage on the sensor C input has fallen under its lower limit. Low is about the signal; the temperature it implies depends on the element. Volex fits its NACS inlet with NTC thermistors of 100 kΩ at 25 °C and a B value of 4150 K, whose resistance shrinks as they warm, so with a pull-up a very low voltage stands for an absurdly hot contact. Amphenol's NACS inlet watches DC+ and DC- with PT1000 elements instead; there the same low signal reads as implausibly cold. A short to ground pulls the line down whatever the element, and so can water or corrosion bridging the sensor pins. No manufacturer documents P2E4C publicly, and no thresholds are published. Unlike a true overheat verdict (P2E4E), the circuit is suspect here. P2E4D is the high-signal counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 4C

Possible causes

  • Sensor C signal wire shorted to ground high
  • Water or corrosion bridging the sensor terminals in the inlet or its connector medium
  • Temperature element C shorted internally medium
  • Measuring input of the evaluating module defective low

Symptoms

  • Charging blocked at once or ended shortly after start
  • Charging system warning
  • Fault may follow rain or a car wash

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E4C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication