OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E45

Hybrid/EV Electronics Coolant Pump B Enable Circuit

Some designs switch electronics coolant pump B on through a separate enable line or a relay, independent of the speed command; P2E45 reports a fault in that path. GM's 2018 hybrid tables show the scheme for pump A: with the enable output active, more than 0.6 A on the line counts as a short to ground (P1F44); with it inactive, more than 35 µA or a line voltage under 4.5 V counts as a short to voltage (P1F45), each after 16 of 20 samples at 250 ms, Type B. The 2016 tables list the same pair. Mitsubishi's 2022 Outlander PHEV powers its electric water pump through a relay energised by the PHEV-ECU and names that relay among the causes of its pump speed code P10D9. No manufacturer documents P2E45 itself. Without enable the pump stays dead although the command signal is fine. Pump A's code is P0CED.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 45

Possible causes

  • Enable wire open or shorted between module and pump high
  • Pump relay or its fuse failed, where the design uses one medium
  • Faulty enable output in the controlling module low

Symptoms

  • Pump B never starts although commanded
  • MIL and hybrid or charging warning
  • Power or charging limited as electronics heat up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E45

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication